If the diagnostic LED is not illuminated or flashes, the safety circuit may have tripped and the truck may not drive. 24-volt default setting.\r\rIf not using seat switch \(Pin 5\), replace switch with jumper wire to B-.\r\rPin 4 should not be connected until after controller is turned on.\r\rController should be mounted to a paint free metal surface with thermal transfer grease.\r\rAccelerator potentiometer should travel from 0 to 5k for Min to Max speed.\r\rFuses are recommended in case of wiring short circuit.) Pin 4 should not be connected until after controller is turned on.Ĭontroller should be mounted to a paint free metal surface with thermal transfer grease.Īccelerator potentiometer should travel from 0 to 5k for Min to Max speed.įuses are recommended in case of wiring short circuit.) The MillipaK is designed to work with the Calibrator currently in use with SEVCON's MOS90 Sevcon Gen4 controllers are designed to control 3-phase ACProven and dependable Sevcon Gen4 controls are built for tough industrial applications Sevcon gen4 pdf.
If not using seat switch \(Pin 5\), replace switch with jumper wire to B.
0 kommentar(er)
